Material loss during production not only has an immense impact on the environment, it also means that plastics manufacturers and processors see their profitability suffer. For this reason, plastics associations around the world are participating in an initiative called "Zero Pellet Loss" or "Operation Clean Sweep," which aims to prevent the loss of plastic pellets along the entire supply chain. This is also the case with the "Zero Pellet Loss" initiative from the Industrievereinigung Kunststoffverpackungen e.V. It has identified three process steps where plastic pellets are lost particularly frequently: at the unloading point in the silo area, during the handling of pellet containers and bags, and directly at the conveying systems and conveyor lines.
But it is mainly during production that significant granulate loss occurs. For example, metal separators, which are necessary to protect the equipment, inevitably also discharge contaminated material. However, this discharged material often contains a large proportion of good material in addition to the metal contaminants. Since the rejected material must then be disposed of, this automatically means loss of value and additional costs.
Effective recovery of this rejected good material has many advantages - for the environment as well as for the profitability of plastics manufacturers and processors. Precious resources are conserved, since the recovered granulate can be fed back into the process 1:1 as a valuable raw material without jeopardizing process reliability. At the same time, this has a positive effect on the profitability of the plastics processor or manufacturer.
The recovery of the rejected good material is also decisive for material efficiency, since with the aid of appropriate technologies almost 100% of this good material can be fed back into the process, so that only a tiny proportion has to be disposed of as waste. And last but not least, granulate recovery has a positive effect on the image of the respective company. In times like these, when environmental protection and the avoidance of plastic waste are increasingly attracting the interest of the public and consumers, only those who take responsibility and act accordingly will be successful in the long term.
With innovative metal separation units, contaminated plastic granulate can be reliably cleaned of magnetic and
non-magnetic metal foreign bodies, regardless of where it comes from, and
recovered for reuse in production. To do this, the material is
first fed into the separation unit via a material hopper. The material is
separated by the so-called vibrating chute and then passes through a magnet
which separates ferrous metal parts. The pre-cleaned material then passes
through a metal separator, which reliably removes the remaining magnetic and
non-magnetic metal contaminants. What remains is the processed, pure granulate,
which can be used again for production and does not have to be disposed of as
waste. Depending on the dosage and settings, a recovery rate of up to 98
percent is possible.
Such a metal separation unit has a positive effect on process reliability, as the smallest metal particles and even metal inclusions in the granules can be reliably detected and separated. If these remained undetected, they could in the worst case lead to damage to the equipment. These systems can be used both in incoming goods and in production and material storage. In this way, the causes of contamination can be quickly identified and a supplier quality check can be carried out as early as at goods receipt.
Far too much plastic granulate is wasted in the
production and processing of plastics, which is neither ecologically nor
economically tolerable. Increasing material efficiency is a crucial step for
the plastics industry to combine economy and circularity. This can be remedied
by state-of-the-art mobile metal separation units that reliably remove metal
particles from plastic granulate that has previously been discharged from the
production process. This not only saves valuable raw materials and costs, but
also has a positive impact on the environment and the company's image.